Quote:
|
Originally Posted by GEREN
Then it's a matter of understanding what each of the 7 pins on the factory module are for:
 |
Oops. I knew there was a really good reason why few (nobody) has done this before !!!
Because of the side-stand part of it, you can't replace the whole relay. It must stay in place.
Looks to me like you need a 2-pin electronic flasher (does that even exist?) to connect JUST to the flasher wires. The electronic flasher may have 3 pins with the extra one going to ground.
Good luck! You are in uncharted territory, I think.