Forum: Parts & Accessories
10-12-2013, 12:31 PM
|
Replies: 14
Views: 15,405
Re: Looking into parting out my 2003 GZ250
I started Parting out my gz250 back in August my bike was running but had a blown head gasket and had 16000 miles on it. There were GZ's in my area selling for $600 that were much newer and better...
|
Forum: Parts & Accessories
09-17-2013, 10:57 PM
|
Replies: 24
Views: 12,833
|
Forum: Parts & Accessories
09-17-2013, 04:53 PM
|
Replies: 4
Views: 4,642
Re: Looking for rear wheel Assebbly
The tire was made on the 30 week of 2008 so it is 5 years and 8 weeks old. I purchased it in late 2009 and I really never rode the GZ that much after March of 2010 when I bought my new bike. It has...
|
Forum: Parts & Accessories
09-17-2013, 01:04 PM
|
Replies: 4
Views: 4,642
Re: Looking for rear wheel Assebbly
I happen to be parting out my GZ 250(http://www.gz250bike.com/forum/viewtopic.php?f=11&t=6767) and still have the rear wheel assembly. The tire has very good tread, I think there were only about 1000...
|
Forum: Parts & Accessories
09-04-2013, 10:00 AM
|
Replies: 24
Views: 12,833
|
Forum: Parts & Accessories
08-27-2013, 12:25 PM
|
Replies: 24
Views: 12,833
|
Forum: Parts & Accessories
08-13-2013, 05:11 PM
|
Replies: 24
Views: 12,833
Re: Parting Out 1999 GZ 250
Yes I did go to Embry Riddle until last year when I ran out of money to keep feeding them with. Now I am looking to transfer to another school. When I started I wanted to learn to fly and study...
|
Forum: Parts & Accessories
08-13-2013, 04:58 PM
|
Replies: 24
Views: 12,833
Re: Parting Out 1999 GZ 250
I have no problems with questions. :cool:
There is a rattling noise when the engine is running which is one of the reasons I am a little worried of the condition of the upper engine components....
|
Forum: Parts & Accessories
08-12-2013, 02:46 PM
|
Replies: 24
Views: 12,833
Re: Parting Out 1999 GZ 250
@ way
The engine runs pretty rough and I am not sure of the condition of the cylinder jug and head. Assuming everything is in good condition I would offer $130 + shipping for both the cylinder jug...
|
Forum: Parts & Accessories
08-10-2013, 12:23 PM
|
Replies: 24
Views: 12,833
Re: Parting Out 1999 GZ 250
The Gas tank is in good condition. The top of the tank has a lot of small scratches that can bee seen up close but not from a distance. I would offer $85 for the tank and $30 for shipping for a total...
|
Forum: Parts & Accessories
08-07-2013, 04:53 PM
|
Replies: 1
Views: 3,423
Re: WTB Gas tank
I happen to be parting out a 1999 dark green gz 250.
http://www.gz250bike.com/forum/viewtopic.php?f=11&t=6767
|
Forum: Parts & Accessories
08-07-2013, 12:21 PM
|
Replies: 24
Views: 12,833
Parting Out 1999 GZ 250
I have decided to part out my 1999 GZ 250 with 16400 miles on it. I have owned it for almost 6 years now. Since I got my new bike about three years ago it hasn't been ridden very much and has spent...
|
Forum: Parts & Accessories
07-25-2011, 02:04 PM
|
Replies: 68
Views: 23,318
Re: 2003 parting out.
Do you have any of these parts left: handlebars, front sprocket cover, speedometer cable/hub?
|
Forum: General GZ250 Talk
10-27-2009, 05:29 PM
|
Replies: 11
Views: 6,155
Re: Parts started falling off my bike today!
I lost my left rear turn signal, while riding back from Orlando to Daytona. It was usually loose and I was always tightening it, in fact I tightened it before I left, but when I got home it was gone,...
|
Forum: General GZ250 Talk
05-26-2009, 10:41 AM
|
Replies: 1
Views: 3,237
Riding in flood water!
My street had about a foot and a half of water over it at its deepest point. I had to get to work and the gz is my only way. I had to lift my feet up so I wouldn't fill my shoes with water. Water was...
|
Forum: Lessons Well-Learned
05-26-2009, 10:16 AM
|
Replies: 10
Views: 6,229
|
Forum: Gadgets & Farkles
05-26-2009, 10:05 AM
|
Replies: 35
Views: 11,794
Re: led kit and visability at night
I have two sets of LEDs that have two lights .each, on set is green and the other white, they do increase the viability of the bike especially from the side.
I found out that here in Florida they...
|
Forum: Other Models/Manufacturers
12-04-2008, 09:43 AM
|
Replies: 3
Views: 3,258
Re: Helmet Visor help
I have the same problem. I have tried using the anti-fog spray/wipes on the sheild which seems to work a little bit.
However I saw this mask at Cycle Gear that seems like its a goog idea.
...
|
Forum: Complete Bikes
12-04-2008, 06:37 AM
|
Replies: 8
Views: 4,043
|
Forum: Other Models/Manufacturers
12-04-2008, 06:31 AM
|
Replies: 63
Views: 17,608
Re: My new bike - 1983 Kawasaki KZ550
Nothing really historical about it. It was just owned by someone in the military or a civilian who worked on a military instillation. It is a decal that must be put on the vehicle before you can...
|
Forum: Riding Safety & Tips
12-02-2008, 02:29 PM
|
Replies: 38
Views: 17,273
Re: LED Turn Signal on the Vest >> Is it O.K.?
I bought this stuff called RainCoat at Cycle Gear, it comes in a little packet for $.99, it is a wax that you put on the shield that repels water.
http://www.cyclegear.com/spgm.cfm?L1=&L ......
|
Forum: Complete Bikes
11-29-2008, 05:26 PM
|
Replies: 3
Views: 2,616
|
Forum: General GZ250 Talk
11-29-2008, 12:05 AM
|
Replies: 81
Views: 18,039
Re: Speed Record for the GZ250
A GPS is great for places you don't know however they are not always 100% accurate even when updated. Even my GPS got lost in Atlanta. O_o
As for the GZ doing 103 , it probably could but not...
|
Forum: General GZ250 Talk
11-11-2008, 06:47 AM
|
Replies: 10
Views: 7,668
Re: exhaust
No, there isn't any.
Do a search here for "exhaust". Most who have tried to make their bike "louder" end up putting it back (I did). It just ends up sounding like a lawn mower without a...
|
Forum: General GZ250 Talk
11-07-2008, 12:49 AM
|
Replies: 11
Views: 5,375
Re: Condensation on seat
A bike cover might not be a bad idea. I'm not sure it will prevent condisation on the seat, but I guess that it couldn't hurt. :??:
However you might want to have saddle bags or some other kind...
|