Forum: Troubleshooting
11-16-2017, 05:36 PM
|
|
Replies: 14
Views: 7,397
If anyone was following this I finally figured...
If anyone was following this I finally figured out the issue. The choke plunger and its seat were dirty and sticking half open or not sealing properly. It seemed like it was slowly leaking and then...
|
|
Forum: Troubleshooting
11-10-2017, 07:48 PM
|
|
Replies: 14
Views: 7,397
|
|
Forum: Troubleshooting
11-10-2017, 04:47 PM
|
|
Replies: 14
Views: 7,397
Thanks for the advice! What does the mid jet...
Thanks for the advice! What does the mid jet control? The diagram that I have from the manual says there is a pilot jet, main jet, and starter jet. I thought that the starter jet was just for the...
|
|
Forum: Troubleshooting
11-06-2017, 09:59 PM
|
|
Replies: 14
Views: 7,397
To anyone interested: pod filter is on(52mm, a...
To anyone interested: pod filter is on(52mm, a 50mm would probably fit as well), open exhaust, 140 main jet and the washer from the needle switched to the other side of the clip. Pilot screw is...
|
|
Forum: Troubleshooting
11-04-2017, 07:26 PM
|
|
Replies: 14
Views: 7,397
|
|
Forum: Troubleshooting
11-04-2017, 07:14 PM
|
|
Replies: 14
Views: 7,397
|
|
Forum: Troubleshooting
10-31-2017, 07:20 PM
|
|
Replies: 14
Views: 7,397
Good point. I was not sure how sensitive these...
Good point. I was not sure how sensitive these little bikes were to mods but apparently they are already lean from the factory and I am sure the straight through exhaust is not helping. I still...
|
|
Forum: Troubleshooting
10-31-2017, 04:25 PM
|
|
Replies: 14
Views: 7,397
Thanks again the new choke cable is on its way...
Thanks again the new choke cable is on its way here now. I am still on the lookout for a plunger style choke to clean up the bars a little bit so if anyone knows where to get one let me know!
The...
|
|
Forum: Troubleshooting
10-29-2017, 07:39 PM
|
|
Replies: 14
Views: 7,397
|
|
Forum: Troubleshooting
10-27-2017, 08:00 PM
|
|
Replies: 14
Views: 7,397
New gz250, need help!
I just picked up a 2004 gz250 for cheap and I am now trying to get the bike running well. When I brought the bike home it was leaking and I saw it was missing the nut holding the head and cylinder...
|
