![]() |
2005 Gz250
2
|
Re: 2005 Gz250
CLEAN.
Looks good. |
Re: 2005 Gz250
Nice. I wanted to go without the rear seat as well, but when I removed it I found a nasty blemish in the fender underneath. Bummer.
|
Re: 2005 Gz250
PS: I'm on the island as well-- east end.
|
Re: 2005 Gz250
The blemesh under your seat is likley from a poorly installed set of saddle bags by a previous owner.
|
Re: 2005 Gz250
Quote:
How bad is the blemish, because if it is not super deep, you can use this stuff on it http://www.meguiarsdirect.com/detail/MEG+G17216 I used it on the gas tank of the bike I have now, it had swirl marks on it so bad that it looked like someone polished it with 1000 grit sandpaper or something, and now it is almost completely slick looking again. :2tup: |
Re: 2005 Gz250
No previous owner; the bike is brand new. As for fixing it, it needs to be both ground down and filled-- nasty. I'll look into that stuff, thanks.
|
Re: 2005 Gz250
Quote:
|
Re: 2005 Gz250
Your first entry says the bike is a 2005?????
|
Re: 2005 Gz250
I
|
Re: 2005 Gz250
Ok, sorry,didn't look close enough.
|
Re: 2005 Gz250
Im with 'ALANTF' should be fixed under warranty.If gouged deeply fender should be replaced as any filler put in a plastic fender will 'show thru in a short time.
|
Re: 2005 Gz250
Quote:
:) |
Re: 2005 Gz250
[q
|
Re: 2005 Gz250
Quote:
|
Re: 2005 Gz250
Danny, I have seen a specific swirl remover wax at an auto parts. Old timers set in, can't think of where but it is out there just keep an eye out.
|
Re: 2005 Gz250
Quote:
:) |
Re: 2005 Gz250
Can you tell me where you get the chrome edge trimming on the faenders and tank??? Not sure if it comes that way from Suzuki or you got it somewhere else. It really makes the fenders stand out from the rest of the bike. I have a black one and would like to see if I could get the same chrome trim you have. Nice picture of your motorcylce, looks great.. Thank you. GZ Brian
|
Re: 2005 Gz250
G
|
Re: 2005 Gz250
M
|
Re: 2005 Gz250
I got the chrome edging at my local Advance Auto store. Cost was $12.99 for 18'. So far I have the back and rear fenders done. I will be doing the tank tomorrow. We also have some nice tank decals coming, and are looking into side panel decals. I have pics of the bike before, and will take some after and get them posted when I am done. So far my wife and I are really liking our GZ 250. Thanks for all the info. GZ Brian
|
All times are GMT -4. The time now is 02:04 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.