View Full Version : New Head & Cam Shaft
Old School
03-05-2012, 04:20 PM
The saga continues. As we pulled the head off today we found some clogged oil ducts. Appears by the damage to the cam that they have been clogged for years. Not only do I need a new cam shaft but also the bearings and seats are badly worn inside the head. Anyone know what or where I might start for a solution?
blaine
03-05-2012, 04:28 PM
The saga continues. As we pulled the head off today we found some clogged oil ducts. Appears by the damage to the cam that they have been clogged for years. Not only do I need a new cam shaft but also the bearings and seats are badly worn inside the head. Anyone know what or where I might start for a solution?
I think if it was me,I would look for a low mileage used engine or at least a head.If you go to all the work to repair that head,you still end up with a head with a repaired spark plug hole,that can cause problems down the road.
:) :cool:
Old School
03-05-2012, 04:31 PM
I here you, looking for a new head and cam shaft. I'm not really wanting to have the old one re-machined. Any place I out to start out looking?
blaine
03-05-2012, 04:43 PM
I here you, looking for a new head and cam shaft. I'm not really wanting to have the old one re-machined. Any place I out to start out looking?
E-bay probably the best,next to here. :) :2tup:
Water Warrior 2
03-05-2012, 08:45 PM
How did the cylinder wall look ?? Any scuffs or gouging from the thread particles ??
Old School
03-05-2012, 09:26 PM
Cylinder wall and everything looked great, I'm going to clean some deposits, off the top of the piston before I put it back together.
blaine
03-05-2012, 10:18 PM
Cylinder wall and everything looked great, I'm going to clean some deposits, off the top of the piston before I put it back together.
That's good to know. :) :2tup:
Water Warrior 2
03-06-2012, 03:27 PM
Cylinder wall and everything looked great, I'm going to clean some deposits, off the top of the piston before I put it back together.
That is good news. Looks like you dodged a bullet there.
vBulletin® v3.8.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.