View Full Version : Troubleshooting
- Turn signal problems.
- Got a small oil leak
- starter is not showing energy
- over heated now loud noise
- No power to my headlight
- Bike dies down on me.
- Gear shift lever and "what's that noise?" Question
- Bouncing at speed.
- choke cable disconnected?
- Pulsing/Surging Bike
- 2005 Front Fork; Can I use different years?
- A little leaky
- Issue removing standard NGK spark plug.
- engine boggs down while accelerating
- specifications
- Headlight, tail light, and running lights misbehaving
- Brake light and tail light separate fuse?
- Flash Relay
- lacks power on the highway
- Why is there gas in my air filter?
- oil leaking fron crank case
- Mechanic left rear drum too tight!
- Can a petcock be soldered??
- Speedo issue
- New problem I haven't found on the forum, bike won't start, please help.
- Starting problem, advice before I plunge in?
- What to do with a detonated top end
- Intermitten Start Problem
- Chain noise after 16t sprocket change
- 2002 GZ 250 dies while driving
- GZ250 Surging & Backfiring
- Bypassing clutch switch
- Stripped carburetor drain screw head
- Carburetor Rebuild Kit - Ebay Item?
- Carburetor Teardown - Help Requested
- Choke wont work
- choke knob
- difficult to get into first gear
- First time out, couple questions
- Newbie Rider can't get bike to start.
- Did my first ever valve adjustment
- Lights/ignition work but won't crank
- I want this GZ but will it be too much trouble?
- Clutch release camshaft
- Clutch cable snapped
- throttle cable broken
- Clutch or something started ticking wen i slowed to stop ?
- No Acceleration at 40MPH
- Oil in airbox
- Leakdown test.
- Engine head oil leak.
- Temporary no start
- In search of best new tires for my daughters gz
- Speedo stopped working
- caliper holder bolt ????
- wont stay running
- 06 gz
- Turn signals work, parking lights don't
- Good (but reasonably priced) plastic adhesive?
- Electrical Problem
- New Handle bars
- Broke my bolt
- Adjusting the brake pedal
- Odd issue, also it won't start
- Large Pop...Is it the end
- Rear brake squeal and lining gauge reading?
- Intake valves? Need diagnosis - video/audio provided
- GZ250 wont start
- Loose hose under the motorcycle
- Crankshaft bolt size
- Engine timing
- Starting was getting harder. (apparent solution)
- Charging system issue
- Riddle me this. Riddle me that. BACKFIRE?
- valve clearance adjustment help
- carb HELP
- Dead Battery
- Valve Lock nut will not lock.
- changing gears
- Starter problems
- changing clutch plates and springs
- GZ125 electrical fault
- Bike won't run without choke
- New to the forum, have backfire issue
- Bike Died mid Ride, Now wont start
- right side cover broke at top
- So I started at the corner store and BANG
- Soot on leading edge of oil filter area
- Loose cylinder head bolt
- 2007 cylinder head
- Gasket in between head and cylinder?
- fuse keeps blowing
- Up shifting suddenly very difficult
- New handlebars, won't start!
- CDI Pinouts
- Gz250 Will Not Start With Video
- Is my timing off? Bike won't run without choke and throttle
- Gz250 wont take throttle
- I can't keep it running...
- Can't keep bike running, seems to die with throttle.
- Valve Issue?
- High idle, no idea
- Died mid-ride, runs now; seeking opinions
- Exhaust valve noise. How much is OK?
- fuel leak/ no cold start
- Trouble getting to my spark plug
- Quick valve adj query.
- Exhaust Valve dropping
- Whts the name
- Indicator issue
- Carburetor kit
- Turn Signal Install?
- So... electrical problem... This should be fun.
- Headlight Turn Signal wire connections
- Bike wont start have spark and compression.
- Can't shift after coming to stop in 2nd gear
- Broken bolt? Hard starting...
- Spark Plug? Air leak?
- Engine possesed by demon
- Air filter - clean or replace?
- cams/valves... top end noise
- Sounds like crap.
- Choke cable
- white smoke from tail pipe
- No Start - Compression?
- Rear brake wear indicator - clarify please!
- Gas in oil
- Won't idle when warm
- Hard to start, low power
- Bike Idles High, Tan oil, runs with idle screw disconnected
- Throttle and headlight in the HOV lane
- no power midrange up. easy start. perfect idle
- Occasional miss/bog at idle - Gas in airbox
- Bike will not start
- Cables for 12 inch ape hangers
- Having real hard time with Carb.
- Rocker Arm Shape
- bad noise
- sound like a train when accelerating
- Trouble changing brake pads
- Bad Voltage Regulator
- Carburetor Issue
- Brake advice to cure my insanity
- Bike stalling out within a few mins of riding
- Should I be concerned?
- Top End Rebuild?
- 2005 GZ no neutral light
- Lost electrical power
- Can jump start, runs rough for a bit, and dies -
- Hose that goes no where
- Removing the CA EVAP system
- GZ 125 no spark
- No Power, Battery tests good
- GZ250 Carburetor Clogged again!
- Indicators working one side only
- Headlights not working
- No Spark condition solved
- Oil leak around cylinder stud bolt
- 2005 engine into 2001 frame?
- 2001 GZ250 Rocker Arm Shaft Removal
- rear running lights not working
- odd air leak symptoms. 02 gz250
- gas in oil...next steps?
- Cold cranking amps
- carb question
- start questions
- carb parts
- High Idle
- Carb rebuild
- Bike won't start
- Brake and clutch cable problems
- Carb repair idle problem jets interchanged
- GZ carbs suck...
- Head gasket issue.. HELP!!!
- Won't start up. Power issue
- new battery no power at all, what next?
- Starting and running issues
- Carburetor Assembling
- Cleaned Carb wont run correctly.
- Part numbers for carb jets.
- 2006 Suzuki GZ250
- Shifter linkage
- So I'm thinking of relocating my R&R assy......
- Bike won't throttle up.
- Carburetor Hose
- No Spark!?? Replaced ALOT
- Clunk noise when using rear brake
- Pcv (crank case pressure)
- New GZ Project - Lesson Learned - Stumble Off the Line
- soft disc brake
- Lighting Issues
- Turn Signal Switch = Bane of My Existence
- Lacking Power-Part Name or Number?
- Shift lever clearance
- Bike dies when throttle engaged
- Backfiring after new stator install
- Got New (to me) Bike Today.....how to ?
- New (to me) Bike Choke Control
- GZ250 Won't Start
- Carb Air/Fuel mix screw....Where?
- Need Touch Up Paint (source)
- 2005 GZ Leak Starting problem leaks from cylinder near exhaust
- Carburetor Rebuild Questions
- Tired of Wire Wheels
- Oil on Cylinder ,?
- Replacement Screw - Right Side Cover 2000 gz250
- Speedometer doesn't work - 2001 gz 250
- Pickup coil
- Running lights and blinker issues
- Lacking power in 3/4/5 gear
- GZ250: Idles ok, but when throttled up engine cuts
- GZ 250 spewing oil and smoke.
- bogging & jerking at full throttle
- My 99 Gz250
- No Low Beam and extra connector in Headlamp
- 03 GZ250 power died after hitting starter button.
- Changing cylinder head
- Missing Air Filter
- Backfiring and no power
- New gz250, need help!
- A couple problems
- Post seizure
- Carb (I think) problems, flat spots
- Bike won't stay running.
- was idleing and died
- fuel & oil in air filter box
- Turn signals not working
- Keeps cutting off
- Carb problem,no acceleration
- Idle problem plz help
- Charging issue
- Rear Axle Noise
- Gz250 battery not charging and stator and rectifier tested please help
- No Electrical & Melting Cables
- No Throttle Response in 4th 5th Gear
- Maxing out at 40mph
- No vacuum above 2-nd gear.
- Extremely sluggish-to no crank.
- Idle to high
- Starter switch
- Rebuilding engine
- Horn blares when turning key on
- Fried bike
- Bike shuts off when put into gear.
- rear running(marker) lights not working
- Interesting Charging Dilemna
- CDI for 1999 Model
- Rectifier grounded directly to frame?
- Bike will not crank over
- Valve adjustment help
vBulletin® v3.8.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.